C-BUS into TAC

Hi everyone,

I have a project that requires for the lighting C-Bus and the TAC BMS for the management.

How can I have C-Bus into TAC and to be shown into the same central PC?

Thanks Hlias

 

If you talk with the TAC people in Australia, they should be able to help you with this.

 

cbus and tac on one sxcreen.

canbe done but you ca bee sure the blown glob in the loo is TAV's fault.. best solution, get a cpl of cheep pcus and a kvm swicth then go forth and control as you wiil!

 

I know TAC were working on an interface but I don't the status of it. I think it may have been completed. Another way would be to use C-Lution and then use OPC to talk to the TAC system. I know the TAC OPC server software is available and works as we use it to talk to Citect (aka C-Lution).

Cheers, CC&C

 

hi

Cbus to xenta ?
what 's the target ?

if only HMI or GUI, you can use OPC, Cbus as a slave.

913 tac xenta is interface as master to cbus, conected via cbus pc PC RS 232 (as slave).. but it is really expensive, cause you need hardware and licences also..

think another way like OPC server

rgds

vincent