Application Log not working in toolkit

Discussion in 'General Discussion' started by L Plater, Nov 18, 2019.

  1. L Plater

    L Plater

    Joined:
    Sep 2, 2019
    Messages:
    2
    Likes Received:
    0
    Apologies if this has been answered previously but i have a site that has multiple networks all connected via network bridges. The problem i have is that 2 of the networks will not show any thing in the application log even when switches are turned on etc the log screen remains blank. We also have a NAC that we use as cni and when i go in to the objects tab it doesnt show lighting levels etc. I have tried different things and had no luck so far so if any has some suggestions im all ears.
     
    L Plater, Nov 18, 2019
    #1
    1. Advertisements

  2. L Plater

    Ashley

    Joined:
    Dec 1, 2005
    Messages:
    974
    Likes Received:
    73
    Location:
    Adelaide, Australia
    How are the bridges configured? If you do not have have application connect mode enabled switch presses will not cross the bridge as they do not include routing information.

    Note: Don't just turn on application connect mode unless you understand the ramifications.
     
    Ashley, Nov 18, 2019
    #2
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.