Add C-Bus Enabled units to toolkit1.1.4

Discussion in 'C-Bus Toolkit and C-Gate Software' started by rabbie2, Feb 7, 2005.

  1. rabbie2

    rabbie2

    Joined:
    Dec 27, 2004
    Messages:
    3
    Likes Received:
    0
    Location:
    Scotland
    Hi Team,

    I joined the forum recently as a new member, because my installer left me in the lurch on a self build house, and I am trying to sort out the system.

    My question is that all the key switches, dimmers, etc have been added using C-Bus enabled techniques, and I now would like to add them to my network setup in Toolkit 1.1.4, and a PCInterface, what is the easist way?

    I have tried transfering a unit to a network using 'unit-network' button, but had "error occured - does not have corresponding match". Then discovered that all the units do not exist!

    I then tried using add unit, using serial number, but no boxes now exist, and serial numbers aren't always on the unit!

    Can anyone help, at least with a few ideas to try?

    Thanks
    Bill
     
    rabbie2, Feb 7, 2005
    #1
  2. rabbie2

    Richo

    Joined:
    Jul 26, 2004
    Messages:
    1,257
    Likes Received:
    0
    Location:
    Adelaide
    Richo, Feb 7, 2005
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.