5500DMX Stops Sending DMX

Discussion in 'Third-Party Solutions' started by Justin Baker, May 27, 2019.

  1. Justin Baker

    Justin Baker

    Joined:
    May 23, 2018
    Messages:
    1
    Likes Received:
    0
    Hey All,
    just wanted to find out if anyone has experienced the same problem i have noticed on 3 different jobs now. Multiple DMX Units on the Same Network just randomly locking up, No Errors on the Network and the Units Lights are all flashing as if they're operating properly but they just dont seem to be sending the DMX Data to the Lights and Dimmers attached.

    At first i thought it might have been environmental but then it happened on two other jobs at different locations.

    Only way to fix it is to reboot them (disconnect give them a few seconds and plug them back in)
     
    Justin Baker, May 27, 2019
    #1
  2. Justin Baker

    jboer

    Joined:
    Apr 27, 2012
    Messages:
    458
    Likes Received:
    35
    Location:
    Sydney
    jboer, May 28, 2019
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Sending Hex through serial port

  2. Sending RS232 to PAC

  3. Sending information to CIS technical support

  4. C-Gate stops responding on port 20023

  5. DMX - 550DMX - Documentation shows DMX Desk?

  6. LED Strip light / DMX gateway / DMX driver

  7. PAC Stops Running

  8. Logic stops running when I disconnect PICED from the WISER 2

Loading...