5104DTSI temp unit found but not reading

Discussion in 'C-Bus Wired Hardware' started by Kevinbutlin, Feb 3, 2017.

  1. Kevinbutlin

    Kevinbutlin

    Joined:
    Jul 9, 2016
    Messages:
    22
    Likes Received:
    1
    Location:
    Minchinhampton, UK
    Hi
    I have installed two 5104's soon after install one has decided to not allow access
    It was setup and could be read in toolkit but would not transfer data to the wiser,
    Now I can not read it in toolkit although it shows up on the network and passes a diagnostic check returning the correct voltage,
    I have tried moving it to another location on the network with the same result
    with or without probes connected

    Has anyone had the same problem and fixed it?
     
    Kevinbutlin, Feb 3, 2017
    #1
  2. Kevinbutlin

    Wonkey

    Joined:
    Aug 3, 2004
    Messages:
    417
    Likes Received:
    39
    Location:
    Adelaide
    Build a small separate C-bus network and see if you can open the unit on this separate network. If you can then you need to investigate your installed network, if not then chances are its faulty
     
    Wonkey, Feb 5, 2017
    #2
  3. Kevinbutlin

    Kevinbutlin

    Joined:
    Jul 9, 2016
    Messages:
    22
    Likes Received:
    1
    Location:
    Minchinhampton, UK
    Thanks Wonkey

    made me think, will try and swap with the working one then if no go will try your idea
     
    Kevinbutlin, Feb 5, 2017
    #3
  4. Kevinbutlin

    Kevinbutlin

    Joined:
    Jul 9, 2016
    Messages:
    22
    Likes Received:
    1
    Location:
    Minchinhampton, UK
    Replaced the unit and got going again.
    BUT network scan still shows the serial number as a network bridge even thou the unit is not connected,
    Assuming it may be a toolkit error or something in the measurement app of the wiser2
     
    Kevinbutlin, Feb 17, 2017
    #4
  5. Kevinbutlin

    Wonkey

    Joined:
    Aug 3, 2004
    Messages:
    417
    Likes Received:
    39
    Location:
    Adelaide
    Try starting a new C-Bus project and see if you get the same results.
    If its OK you can easily copy all your Tags over to the new project.
     
    Wonkey, Feb 18, 2017
    #5
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.