5032 indicators and a single group

Discussion in 'C-Bus Wired Hardware' started by dalise, May 9, 2019.

  1. dalise

    dalise

    Joined:
    May 9, 2019
    Messages:
    1
    Likes Received:
    0
    Hey all,

    I have a system I am working with and need assistance with indicators, I am sure there is a simple answer to this!

    I have a single group (called Exterior lights) with a 2 button 5032 station
    Button 1 is Soft up
    Button 2 is Soft down

    Operationally it works fine however I need the two indicators on the 5032 to mimic which button was pressed last as opposed to the group status. Unfortunately I cannot split it into two groups...hoping there is a answer!
     
    dalise, May 9, 2019
    #1
  2. dalise

    Ashley

    Joined:
    Dec 1, 2005
    Messages:
    1,524
    Likes Received:
    173
    Location:
    Adelaide, Australia
    Unfortunately what you are trying to do is just not possible. The indicators can only be OFF, ON, or follow the group state.
     
    Ashley, May 9, 2019
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. CBus V3 and Neo indicators

  2. Status indicators behaving improperly....

  3. Status indicators between B&W Touch & Schedule Plus not correctly

  4. DLT Indicators?

  5. Relay's status doesn't match group or lamp indicators

  6. Getting status of Single Group

  7. DLT and programing indicators

  8. Nightlight options section in indicators tab

Loading...