12 Channel not working

Lets see what the weekend brings and see what happens 1st before any course of action

 

With brads help we found the source of the issue. It seems the logic I had set up for the alarm set up had gone bonkers. Once i disabled the logic, all went back to normal. Now i have to work out whats caused it from that logic setup. Thanks Brad for all your help

 

Hi Klink,

No problems. It was a 'fun' one ;-)

Alarm triggered output on Ness D16 was pulling high a few 4-5 channel grouped logic groups (on relay logic tab) / GA circuits that happened to be almost all 12 channels on the relay. Obviously a 'light up the house in alarm' config, but the alarm wasn't actually going off at the time!!

Good luck with fixing/programming the alarm interface and hope its not faulty, just confused.

All the best,

Brad