B&W MKII re addressing itself???

[samdonelan]

Hi Everyone,

Having some dramas with a Black and White MKII Touchscreen.

In the project details wizard, on the options page, under the cbus tab.... my touchscreen is being re-addressed to GA 0.

It is a GA 1 on the local network in toolkit.

This is a multi-network site with 5 networks and a local network.

I'm running toolkit 1.11.4 and piced 4.9.2

Any ideas??

[Newman]

Pretty sure this is just a PICED issue, the screen is actually not re-addressing itself. It's only an issue if you plan to try and download to the unit over C-Bus.

[Darren]

Pretty sure this is just a PICED issue, the screen is actually not re-addressing itself. It's only an issue if you plan to try and download to the unit over C-Bus.
Correct.

This is issue number 20504 and will be fixed in the next release of PICED.

[samdonelan]

Thanks for your feedback guys, i thought i must have been doing something wrong!!

[Memphix]

I have experienced this issue. I have just udated from 4.9.2 to 4.10 and the unit address is now as expected.

Was this causing any problems? I have had problems on site with a PACA unit which has had me question com ports (see post http://www.cbusforums.com/forums/showthread.php?t=6986).

I will be returning to site to finish this job and hope that updating from 4.9.2 to 4.10 will solve this communication problem

[Newman]

It will cause problems if you try and download your project to the unit over C-Bus, but shouldn't cause problems otherwise. Certainly update to PICED 4.10, test it out and let us know how it goes.

[Memphix]

Software update resolved the "visual" problem with the unit address number defaulting to 0.

As for the other confusion, my bad. Was in the mind-set I had programmed logic to "set scene" when in fact I had just selected a lighting address called scene set to on. Added the lighting address to the scene trigger, then it all worked :rolleyes: