Updating the Network View

[Charlie Crackle]

Duncanrm

As this thread is locked

http://www.cbusforums.com/forums/showthread.php?t=341

Continuing Again here.. (Using toolkit 1.1.4)

I have managed to find all except 5 units which are not calculating. (Buy adding new units and then looking at catalogue number)

I know one of these 5 units is the L5504RVFC. because I am short 200mA on the calculation page. I only have 1 on the network. If I change the catalogue number to "crap" the Calculation current stays the same. Now if I add a new unit called L5504RVFC the calculating currnet goes up 200mA. If I delete this new unit the Calculation current goes down by 200mA. But if I add the catalogue number L5504RVFC to my existing RELDC4 the Calculation current does not go up ?? Does the network view use more that Catalogue number.

Any ideas on how I can find which devices are the last 4 ??

Charles

[Duncan]

Duncanrm

As this thread is locked

http://www.cbusforums.com/forums/showthread.php?t=341

Continuing Again here.. (Using toolkit 1.1.4)

I have managed to find all except 5 units which are not calculating. (Buy adding new units and then looking at catalogue number)

I know one of these 5 units is the L5504RVFC. because I am short 200mA on the calculation page. I only have 1 on the network. If I change the catalogue number to "crap" the Calculation current stays the same. Now if I add a new unit called L5504RVFC the calculating currnet goes up 200mA. If I delete this new unit the Calculation current goes down by 200mA. But if I add the catalogue number L5504RVFC to my existing RELDC4 the Calculation current does not go up ?? Does the network view use more that Catalogue number.

Any ideas on how I can find which devices are the last 4 ??

Charles

Hi Charles,

Its a good question, I'll add a column to the Database View that indicates whether it was involved in the "Network C-Bus Calculation" or not.

[Charlie Crackle]

I know one of these 5 units is the L5504RVFC. because I am short 200mA on the calculation page. I only have 1 on the network. If I change the catalogue number to "crap" the Calculation current stays the same. Now if I add a new unit called L5504RVFC the calculating currnet goes up 200mA. If I delete this new unit the Calculation current goes down by 200mA. But if I add the catalogue number L5504RVFC to my existing RELDC4 the Calculation current does not go up ?? Does the network view use more that Catalogue number.

Any Ideas about whats happening here ??

[Duncan]

Any Ideas about whats happening here ??

Not yet, when I'm back at my desk we'll get it sorted and let you know why its not working.