Ramp to zero

[Dave Byron]

Ramp Groups to Off



When a group address is ramped to level 0, the command is received by all C-Bus Units on the network. On some old C-Bus input units, the status indicator will go off as soon as this message is seen, even though the level is still above 0 for some time. For this reason, many devices send a "ramp to level 1" command followed by an "off" command when the level gets to 1. In this case, the input unit status indicators will show the state correctly. To select this behaviour, select the Ramp Groups to Level 1 then send Off check box.

If this check box is not selected, then ramping to level 0 will be done with a single "ramp to level 1" command.

From Help File

Does this mean that its ramped to 1 then a ramp to zero without a log entry , as the log file in Piced or Toolkit show.

dave

[Newman]

When the tickbox is un-ticked, you should see a single C-Bus command that is simply ramp to 0%, or an Off command.

When the tickbox is ticked, you should see a ramp to 1% command, followed by an Off command.

[Dave Byron]

Newman
That's what I would have thouught too, but see pic.
Going to test on real network.



dave

[Dave Byron]

This is how the button is set
dave

[Dave Byron]

Newman
If I click the button with a short press level go 0, 100 but if set on and use the dim action group goes to 1%
not zero but as the shutter closes that is all I want.

Case closed for me, but Piced not do as you say

tks
dave

[Newman]

That checkbox only applies when you're ramping groups off over a period of time, like in a Scene. If you're using a dimmer key to dim up/down a group and control your blinds, then you'll be dimming between 1% and 100%. C-Bus dimmers never dim to level 0 during dimming operations. A dimmer key doesn't ramp to off, so it is unaffected by that checkbox.

It seems to me that your confusion has come from the expectation that dimmer keys dim to off.