SENPILL - Store & 1 2 stuck on 16%

[gsnibson]

I am trying to use the RECALL1 command on a SENPILL Firmware 1.9.00 and cannot seem to set the store % 1 or 2 to anyother value than 16%. The GUI TIMERS page allows me to set the value to anything on the pull down list and save it to the network etc. However when I open the SENPILL device backup again the values have all gone back to 16%

Am I missing something???

Thanks for your help in anticipation

[Duncan]

I am trying to use the RECALL1 command on a SENPILL Firmware 1.9.00 and cannot seem to set the store % 1 or 2 to anyother value than 16%. The GUI TIMERS page allows me to set the value to anything on the pull down list and save it to the network etc. However when I open the SENPILL device backup again the values have all gone back to 16%

Am I missing something???

Thanks for your help in anticipation


Hi,

Can you advise what version of either Toolkit or the V2 software you are using?

[gsnibson]

Duncan,
I tried both the V2.7.9 and the V2.7.7 of the installation software. Both were the same. I then tried a SENPIRSS unit and I could set that fine.

I have 5 SENPILL units and the all exhibit the same issue.