Two channels with same name ?

[Rolecgroup]

Dont know if this is a problem, whether its been previously addressed, or if its correct.

Following import of an old V2 project i was naming all the channels which dont seem to be copied accross.

I dont remember doing it but obviously did, accidently name a relay channel and a dimmer channel with the same name.

When setting up a Neo switch scene, i couldnt figure out how a single named channel was bringing on a dimmer and relay channel.

Should this be possible ?


Thanks



Dean.

[znelbok]

I believe so.
Where I have a circuit spanned across multiple channels of a relay or dimmer, I have names the same so that a key input assigned to that group will control all of the channels.

I dont see why this would not be the same across a dimmer and relay

[george]

I dont remember doing it but obviously did, accidently name a relay channel and a dimmer channel with the same name.

When setting up a Neo switch scene, i couldnt figure out how a single named channel was bringing on a dimmer and relay channel.

Should this be possible ?

Thanks

Dean.

Hi Dean,

There is nothing wrong with the same group being assigned to different channels on different output units. This way you can easily control multiple channels with a single key.

Or you mean you gave the same name to 2 different groups (groups with different addresses)? There was a bug in the version 1.1.1 of the C-Bus Toolkit software which allowed user to create 2 groups with the same name, but with at least one character being in different case. For example, you could have 2 groups: "Kitchen Lights" and "Kitchen lights". Is this what you have? This is fixed in the C-Bus Toolkit 1.1.3.

Regards,
George