Use IR Reader to learn Air-Conditioner remote code

[Sang]

Did anyone try to use IR Reader to learn Air-Conditioner remote code and success to control the Air-Conditioner? I have tried it, but seems it can't work. So anyone can help?

[Conformist]

Did anyone try to use IR Reader to learn Air-Conditioner remote code and success to control the Air-Conditioner? I have tried it, but seems it can't work. So anyone can help?

I would strongly advise against learning air-cond IR strings! They can be long, complicated and often have imbedded, the time and date. This can cause undesired consequences (having experienced it 1st hand quite some time ago!)

Cheers

[Sang]

But the default IR database in CIRCA also have some air-cond. code.

[nickrusanov]

Yes, there is some successful learning experience, but along with some unsuccessful.

[MichaelCarey]

I successfully "re-learnt" IR codes for my LG air con. The default Clipsal ones would not turn on the air con if it was off, they would change the temp but not switch it on.
I borrowed an IR reader from CIS in Adelaide and was able to learn the appropriate codes without too much fuss.
You have to prepare the remote control before you start each read so that the right code is sent by the remote. For instance, the LG sends mode, fan speed, vane movement, etc as well as the temp setting. You have to make sure that the remote is transmitting exactly what you want learnt.

[Newman]

For most split system air conditioning systems the remote control is considered the state master. Each time the air con remote transmits a command it transmits the entire state of the air conditioner including things like mode, fan speed, swing, temperature, time, etc.

If you're going to use the 5034NIRT to control an air conditioner then you need to remember that the entire state of the air conditioner is updated when it receivs a command, not just the individual parameter that you want to adjust.