Making a DLT Dynamic

[Jesmond]

Hi Guys,

A few months ago I saw a DLT programmed to display separate Dynamic Controls depending on which source is selected. I tried to replicate this using the instructions on the MRA installation notes without success. Is there any other literature around the place that can help me work this out ?

Also I need to purchase (read can't be bothered making) 7 Digital Cables (from Matrix to Remote Amps - all are centrally located so 1 mtr each would do) can anyone advise where I can get these or a Clipsal Code?

Regards

[Darpa]

Hey Jes,

I could be wrong, but I think the "digital" cables between the matrix switcher and the amps is just standard Cat5 cabling, you should be able to get some common sized pre-made cables from most computer stores or an electrical wholesaler.

Darpa :)