Help Needed with DSI Gateway

[cbus guy]

i have installed a dsi gateway and am having trouble getting it to work via a scene controller

it will respond to a "master on" command from any key input
but does nothing when a scen controller key is pressed

also channels 2 &3 seem to continually flash (even when turned off) any ideas guys? :mad:

[Ross]

Howdi,
have a good read of this http://www.clipsal.com/cis/pdf_files/1036134_-_5508DSIP_INSTALLATION_INSTRUCTION.pdf

While you are waiting for the official response that is. :)

[Wilko]

i have installed a dsi gateway and am having trouble getting it to work via a scene controller

it will respond to a "master on" command from any key input
but does nothing when a scen controller key is pressed


I'm about to install one of these, and it will be tied into about 60 scenes in a C-touch. What's the general feeling out there on what this problem might be? Is it a programming error, or do DSI gateways have known problems responding to scenes? I would have thought that C-Bus commands are C-Bus commands, regardless of their origin..

[UncleDick]

Just checking this one out, will get back to you

[MikeW]

Cbus Guy,
I have been able to connect up a DSI light and control it via C-Bus. I was also able to control it via a Scene Master.

I have not experienced any issues with control of DSI lighting.

Do you have any control over the DSI with C-Bus at all? (ie via a key switch not a scene master)
I need some more information on your setup so I can try to see what is causing your problem.