Temp Sensor with CTC

[mikegriff]

If i monitor my Temp sensor in PICED or Homegate using Monitor every thing is fine
I set the unit addres and I get the temp
From PICED I then transfer to CTC

Nothing
Well it says ?oF

Any ideas
Also the example in the logic set for Heating/cooling control
Which sensors is that using?

thanks
Mike

[Nathan]

I had the same problem with version 3.2 and a older square temp sensor, now since installed version 3.3 it reads the temp fine.

[Darren]

We discovered recently that this problem can be caused by the temperature sensor having its "error" flag set. This gets cleared by doing a scan with the ToolKit, but only with version 1.1.6 or before, or with the next version about to be released (1.1.10).